If the components of the gas system have been removed, reinstall them as explained below. TOO MUCH PRESSURE COULD CAUSE THE WOOD TO SPLIT.Ģ Components of the gas system-the sleeve, sleeve spring and gas piston will remain in place and do not need to be removed, except for cleaning. Remove the forearm from the magazine tube by unscrewing the magazine cap and sliding the forearm forward, off the magazine tube.ĭO NOT SQUEEZE HARD ON THE OPEN REAR END OF THE FOREARM. First, lock the bolt rearward by pulling the operating handle fully to the rear.
THAT THE CHAMBER, FEED MECHANISM AND MAGAZINE CONTAIN NO SHELLS.ġ Take the receiver in hand. NOTE: Do not depend on the red color alone to indicate your gun's safety status, as time, exposure to the elements, and the abrasive action of cleaning agents can erase it. When installed, the left-handed safety will have the safety button's red warning band on the RIGHT side of the trigger guard. The safely is reversible and can be reversed from right- to left-handed by a competent gunsmith. To move the safety to the FIRE position, press the safety to the left (See Figure 2-B). To place the gun "ON SAFE," press the safety button to the right. In the "off safe" position a red warning band is visible on the safety button on the left side of the trigger guard. The safety is located at the rear of the trigger guard (See Figure 2-A). The cross bolt safety prevents the trigger from being pulled when in the "on safe" position. It is important to follow the exact sequence for assembly in steps 1 and 2, in order to properly assemble your Gold shotgun.ĪLWA YS PLACE THE SAFETY IN THE "ON SAFE" POSITION BEFORE ASSEMBLY PROCEDURES AND CHECK YOUR GUN CAREFULLY TO BE CERTAIN The Gold shotgun is delivered, in the box, with the barrel removed and the forearm still attached to the magazine tube.
The Gold 12 and 20 gauge shotguns shoot all factory lead and steel 12 or 20 gauge 2 3/4" and 3" loads.īrowning can assume no responsibility for incidents which occur through the use of cartridges of nonstandard dimension or those developing pressures in excess of SAAMI (Spoiling Arms and Ammunition Manufacturer's Institute) established standards. Ready to fire (Red band showing on left side)
Browning serial numbers location on barrel shotgun serial number#
The serial number of your Gold shotgun is found on the left side of the receiver-just below the engraving "Gold Hunter."
0 kommentar(er)
